Skip to main content

Lubricate Smart Flex machines

Purpose

Smart Flex machines should be lubricated when the mechanisms make high-frequency noises during movement. Depending on machine use and ambient conditions, this may occur every 2 to 12 months.

Details

Check monthly for any sound exceeding a sound pressure level of 80 dB(A) measured over a 1-meter distance. If this occurs, you may need to lubricate the Smart Flex machine.

Only lubricate Smart Flex mechanisms with Interflon Fin Super. The lubricant can be ordered from EGYM Support (order number: S116-00680-01).

Pas på

Do not use other lubricants. Other products can damage the machine and may void the warranty.

Solution

Switch off machine_edited
Protect surface_edited
Secure the belt_edited
Spray lubricant_edited
Reattach cap_edited

  1. Switch the machine off, wait 10 seconds, and switch the machine on. The pad will move the the end position.

  2. Remove the cap at the end of the belt, protecting the surface of the belt with a paper towel or soft material.

  3. Secure the belt away from the track.

  4. Spray the lubricant along the belt's track.

  5. Reattach the cap.

  6. Move the pad to the opposite position.

    Bemærk

    This step requires trainer rights. Tap your RFID tag twice to log in as a trainer.

  7. Repeat steps 1 to 5 to lubricate the other end of the track.

  8. To check the mechanisms, press two opposite arrow buttons at the same time for approximately 6 seconds. The pad will move through the entire range of motion 5 times.