Wi-Fi requirements
Note
Wi-Fi configuration is only available if you use an EGYM router. An EGYM technician can assist with the EGYM router installation.
Warning
Do not press factory reset button on the EGYM router; this disconnects machines from the network and removes configurations.
Connect the router to a designated power outlet.
Connect the router to the network via LAN cable.
Router position:
1.5 meters (5 ft) above the floor, not on the ground.
Within 15 meters (50 ft) of the machines, ideally with direct line of sight.
Away from sources of interference, such as as other Wi-Fi equipment, DECT telephones, loudspeakers, Bluetooth devices, microwaves, or electrical cardio equipment.
Away from large metallic items such as heaters or iron training weights.
Note
The transmission quality is strongly dependent on the location of the router.
EGYM recommends approximately 15 machines within a 15 m (50 ft) radius around the router. For EGYM machines more than 15 meters (50 ft) from the router, request a wireless access point and connect it to the EGYM router.