Facility preparation
Complete the pre-installation checklist to make sure your gym is ready for the delivery of EGYM Equipment. Refer to the Facility Preparation Guide for more details.
Pre-installation checklist
Complete this checklist before delivery.
Send pictures and videos of your facility to EGYM Order Management, showing the pathway from the delivery access point to the installation areas.
Define machine locations (refer to Machine space requirements).
Contact your EGYM representative about a room plan; an EGYM room plan is required for orders of 3 or more machines.
Follow the Fitness Hub placement recommendations to ensure accurate camera measurements.
Confirm the floor has sufficient load-bearing capacity for the machines (refer to Machine weights and dimensions).
Install a grounded power outlet within 1 m (3 ft) of each machine location.
Plan the WiFi router location or LAN cable routing.
Note
LAN connection is required for the Fitness Hub. A 2 m LAN cable is included with a Fitness Hub order.
Define the LAN cable route to each machine (refer to LAN requirements), or
Define the EGYM router location within 15 m (50 ft) of the machines (refer to Wi-Fi requirements).
Prepare cable management (refer to Cable management options).
Check regional voltage and plug requirements (refer to Power requirements).
If you want to switch all machines on/off simultaneously, ask your electrician to install a panel switch.
Secure a broadband connection with a bandwidth of at least 5 Mbit/s (download), 1 Mbit/s (upload) per EGYM machine (see Network requirements).
Note
Contact your internet service provider as soon as possible. An active internet connection is required for installation.
Make an appointment with a qualified IT technician.
Activate a DHCP (Dynamic Host Configuration Protocol) server.
Set DHCP lease time to a maximum of 12 hours.
Exclude IP address ranges 10.9.x.x and 10.11.x.x in the DHCP server.
Ensure the IP address pool is large enough for 2x the number of planned machines (>100 recommended).
Configure firewall to allow EGYM IP addresses and ports.
Confirm whether RFID wristbands are included in your order or need to be ordered separately, or
Verify third-party RFID compatibility.
Check with EGYM Order Management whether a scale is included in your order or needs to be added.
(Optional) Add a platform scale or a body composition scale to your order.
If you order a body composition scale, start the integration process with the scale manufacturer (see Scale integration overview).